![]() Maybe I did something wrong here because when I printed the partition table it would say linux at the end. I've used fdisk to partition the image: fdisk /sdcard/Win.img, n, p, 1, 1, 65īut still no result. Since it still didn't work I started experimenting on the filesystems and partitions. ![]() Then I found out old windows versions only support up to 4 kB block or cluster size so I made a new one: dd if=/dev/zero of=/sdcard/Win.img bs=4k count=131072 I used the following configuration: dd if=/dev/zero of=/sdcard/Win.img bs=64k count=8192Īnd formatted it with: mkfs.vfat /sdcard/Win.img I think the problem is in the image file. If I disconnected all drives except for the cdrom, the error would still be there. The read error B gave, however, has nothing to do with the image file. A was assigned to the cdrom, B gave a read error, C was assigned to the virtual vvfat drive and the others were unassigned. I used the vol command to identify the drives. The problem is, when I boot into DOS, the disk image is not recognized. I've got the following drives: an empty disk image to install windows on, a virtual vvfat drive with the setup files, and a cdrom drive with the latest version of DOS. You should be able to format any size disk supported by your drive and BIOS by specifying the correct track and sector count. Place the disk to be initialized into drive A and. I'm trying to emulate windows with bochs on my android device. The track and sector parameters are still supported So to format a 1.2M 5.25' floppy simply type: format A: /T:80 /N:15. To initialize (format) a disk means to erase all the old files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |